Clearing The Settings - SOMFY EXAVIA 500 Manuel

10.3 Clearing the settings

When should I clear the settings?
A er programming the gate leaf travel, if you change the opening position stop or if you modify the motor wiring.
In the event of spurious obstacle detection because of normal wear on the gate.
1
>2s
Press the button on the
control electronics for 2
seconds.
The indicator light
comes on.
5 To clear the settings*
Keep button 2 of the remote control depressed until the
RESET indicator light comes on.
6
2
Place the memorised remote
control on the target.
EN - Replacing the EXAVIA 500 / WISPA 800 / SGS 201SGS 400 / SGS 501 electronic unit - SOMFY
3
Keep button 1 of the remote
control depressed until the
indicator light flashes.
To clear the settings* and the memorised remote
5
controls/control points
Keep button 2 of the remote control depressed until all the
indicator lights come on.
Indicator light flashes twice (see page 8 to launch auto-
programming of the leaves' travel).
*Gate travel, deactivation of the settings, etc.
4
Press button 1 on the remote
control once.
The "RESET" indicator light
flashes.
17