Special Operation; Clearing Remote Controls And All Settings; Clearing Remote Controls - Fig. 48 To; Locking Programming - Fig - SOMFY DEXXO PRO io Manuel D'installation

Dexxo Pro io
-
-

10 - SPECIAL OPERATION

restored the door should return to its opening stop; if the door does not reach
11 - CLEARING REMOTE CONTROLS AND
ALL SETTINGS

11.1 Clearing remote controls - Fig. 48 to 50

> Clearing Keytis or Keygo remote controls
Individually clearing a remote control button
- by programming from the Dexxo Pro motor (Fig. 20).
Programming a previously programmed button automatically clears any
previously stored programming settings.
-
(Fig. 48).
PROG
the remote control.
> Clearing all remote controls (Fig. 49)
[1]. PROG
-
- Clear the programming for all memorised remote controls.
[2].
Fig. 48.
> Keytis remote control general reset (Fig. 50)
PROG
-
-
- change the system key memorised by the remote control.
11.2 Resetting all settings - Fig. 51
SET
This clears all previously stored settings and returns them to their default
values.

12 - LOCKING PROGRAMMING - FIG. 52

The keypad must be locked to ensure the safety of the end-users.
Non-observance of this instruction can result in serious injury to
persons, e.g. when trapped by a door.
SET "-" buttons
- SET
- the "+" and "-" buttons must be pressed simultaneously within 2 seconds.

13 - REFITTING COVERS

14 - TROUBLESHOOTING

14.1 Operating codes displayed

11
BUTTON to be cleared on
KEY
WARNING
(Fig. 53).
Code Description
Door opening
Door closing
Obstacle detection
Safety input active
Pedestrian door safety
contact active
Safety mechanism self test

14.2 Programming codes displayed

Code Description Comments
Awaiting setting
learning mode.
Learning mode
cycle.
motor in forced mode.
Awaiting motor Pressing a remote control button will assign
control memorisation this button to motor control.
Add a remote Displayed during remote control
control programming. (One-way controls).
Delete a remote Displayed during remote control deletion.
control (One-way controls)
One-way control Displayed on reaching the maximum number
memory full of channels that can be saved.
One-way control Displayed when all the one-way remote
memory empty controls have been deleted.

14.3 Error and failure codes displayed

Code Description Comments
Maximum
force reached the door requires
too much force for
the motor.
Safety The safety device
mechanism self test failed
self test fault
Other faults These codes
and failure correspond to
conditions various electronic
circuit board
failures.

14.4 Accessing stored data

(Fig. 54).
Copyright © 2015 SOMFY ACTIVITES SA. All rights reserved
Comments
Displayed during obstacle
Displayed after a movement
the safety input is active.
This display is maintained as long
as the safety input is active.
Displayed after a movement
the pedestrian door contact is
open.
The display is maintained as long
as the pedestrian door contact
remains open.
Displayed during safety
mechanism self tests.
SET
OK
+ "-" buttons will control the
Action required?
Check door balance and
correct operation by manual
operation.
P2
correctly depending on the
devices connected to the safety
input.
Check safety device wiring.
alignment.
minutes then re-connect the
power supply.
Somfy Technical Support.
Ud OK