Publicité
This water heater is designed to display diagnostic codes. If there is a poten al operati n concern refer to the
code and remedy on the next page.
To Display Diagnosti Informatio
To display the most recent diagnostic informa on code press and hold the "On/Off bu on for 2 seconds on the
MC-195T controller. While holding the "On/O " bu on press the up bu on. The last 9 diagnosti codes will
ash one a er the other. To exit this mode press the "On/Off and up bu on as before.
To enter or exit the maintenance monitor informa on mode, press and hold the down bu on for 2 seconds and
without releasing it press the ON/OFF bu on.
To obtain the water flow rate: press the up or down bu ons unti "01" displays. The water ow rate will then
appear. For example "58" means 5.8 gal/min.
To obtain the outgoing water temperature press the up or down bu ons unti "02" displays. The temperature
will appear in degrees Fahrenheit.
No.
Diagnosti Codes
Data
01
Water flow rate
02
Outgoing water temperature
Unit
0.1 gal/min
Degrees Fahrenheit
KBP Series Manual
73
Publicité
