Publicité
Mounti g the controller
Ref.
A
B
Inches
2.36
4.65
(mm)
(60)
(118)
1. Make a hole for the wire and a ach the bracket onto
the wall using the included screws(refer to image 1 &
2). In case the wall is made from cement, make 2 holes
(.24in, more than .98in depth) for the wall plug and
a ach them using the included screws (
2. Connect the wire from the heater to the controller wire
of the same color (See image 3).
3. Insert hooks of the bracket into the controller and move
the controller down unti it clicks. (image 3 & 4)
C
D
E
F
2.36
1.58
4.72
1.65
(60)
(40)
(120)
(42)
.
16×.98in)
Do not connect the 120VAC to terminals for control.
Doing so will damage the PC board which would not be
a warranty repair.
G
3.29
(83.5)
Final Checklist
□
The water heater is not subject to corrosive
compounds in the air.
□
The water supply does not contain chemicals or
exceed total hardness that will damage the heat
exchanger.
□
Clearances from the water heater unit are met.
□
Clearances from the vent termina on / air intake
are met.
□
For indoor models, ensure you have used the
correct ven ng products for the model installed
and that you have completely followed the
ven ng manufacturer's installation instruc ons
and these installation instructi ns.
□
For indoor models, verify that the vent system
does not exceed the maximum length for the
number of elbows used and that ven ng is
properly secured.
□
For indoor models, verify that SW 1 in DIPSW 1
has been adjusted for vent length if necessary.
Refer to the sec on on Maximum Vent Length.
□
Purge the water line of all debris and air by
closing the hot isola on valve and opening the
cold isola on valve and its drain. Debris will
damage the water heater. Use a bucket or hose
if necessary.
KBP Series Manual
NOTICE
51
Publicité
