Publicité
How to use the Temperature Controller
Circulation Function (with ti er)
Be sure prior to using the mer that the clock time is correct. Unless the clock is set, the mer se ng will not be
accessible.
1. Ensure the controller is "ON"
2. Press the "TIMER" bu on. "TIMER 1" will be displayed. Timer 1 will be preset for 6AM-9AM and 5PM-10PM.
The range that is programmed will be lled in "white". Each "white" secti n represents 1 hour. When the
tim is in the range that is programmed, the circula on functi n will start automa cally showing the
circula on icon. When the programmed range comes to an end, the circula on functi n will stop
automa cally and the circula on icon will no longer be shown.
3. Press the "TIMER" bu on once more to show "TIMER 2". (The preset is the same as "TIMER 1")
4. Press the "TIMER" bu on once more to exit from timer setti
shown.
The user can alternate between mers by simply pressing the "TIMER" bu on once the programming
has already been completed and exited
When using the "TIMER" func on, the user may want to consider setti
icon block before the desired time water is needed to ensure hot water at the desired time
Example:
NOTE
NOTE
If hot water is desired for 6AM, the program can be set for 5AM to ensure that
at 6AM the water is already at the desired temperature.
KBP Series Manual
and the timer se ng display will no longer be
NOTICE
In the event of a loss of power, the clock
will have to be reset and the ti er
feature will need to be turned back on.
Failure to do so will cause the ti er
feature not to functi n.
the program to be acti ated on the grid
65
Publicité
