Publicité
How to use the Temperature Controller
Se
g the Clock Time
The display will default to "AMPM－－：－－" when
the controller is powered on for the rst me.
1. Press the "ON/OFF" bu on to turn the controller
"OFF"
2. Press the "FUNCTION" bu on while the controller
is "OFF".
"AM 12:00" will be displayed flashing.
3. Press "UP" or "DOWN" bu ons to adjust the
current time.
The "UP" bu on will move the minute forward,
while the "DOWN" bu on will move the minute
backward.
Conti uous pressing of either bu on will change
the time by 10 minute intervals.
Pay close a en on to correctly set the AM vs
PM especially when the recircula on timer
functi n is being utilized.
62
4. Press "FUNCTION" bu on again.
The display will stop ashing and the setti
will be exited.
Remember that when the "FUNCTION" bu on is
pressed while setti
seconds allowing the me to be set as accurately
as possible.
Once the me is set, if the "FUNCTION" bu on is
not pressed to exit the se ng mode, the control-
ler will exit the mode automa cally after 1 minute.
NOTICE
In the event of a loss of power, the clock will have to
be reset. Failure to do so will cause the mer feature
not to func on.
KBP Series Manual
the time, the clock starts at 0
mode
Publicité
