Publicité
Made
in
Germany
Figure. B) Drive in the middle of the lift.
Alternative lifting position
Swivel in the carrier arm and pull out properly to the de-
sired length.
The adjustable receiving plates must be placed at the
points specified by the vehicle manufacturer.
88
5.2 Lifting the vehicle
• Lift the vehicle until the wheels are off the ground. Actu-
ate operating element v "Lift" (see image 4)
• If the wheels are not blocked, interrupt the lifting pro-
cess and check for proper seating of the carrier plate.
• Afterwards, lift the vehicle to the desired working height.
Ensure secure vehicle placement on
the carrier plate, otherwise there is
a danger of the vehicle dropping.
The lift can be controlled several times depending on
i
the load distribution during "lifting".
i
See to it that the lifting arm blocks are ratcheted in after
the vehicle has been accepted.
Figure 4: Operating unit with reversing switch (2.30 SL to 2.40 SL)
On-site a separate lockable main switch must be placed
at a reachable height if the electrical connection of the
lift and electrical interface is higher than 1.90 m and can
only be reached with assistance (e.g. a ladder)!
i
Once the "top" or "low - off" positions are reached two
red LEDs will illuminate on the LED display. To prevent
damage to the lift platform, it is not permitted, while the
red LEDs are illuminated, to alternate between briefly
lower and lift.
5.3 Lift synchronization
• Die Hebebühne ist mit einer elektronischen The lift is
equipped with an electronic synchronous control.
• In the upper area of the lift spindle there is an electronic
potentiometer which acquires the actual position of the
spindles and thereby the lift height of the platform.
• Depending on whether there is a height difference be-
tween both sides (lift rails) to each other, a computer
calculation will stop the more advanced lift rail (inde-
pendently of the lift being raised or lowered), until both
OPI_SMART LIFT 2.50 SL_V4.0_DE-EN-FR-ES-IT
Publicité
