Publicité
Cleaning
EN
Cleaning the casing
Sharpening can result in a fine dust settling on the housing and in the
guiding slot of the V-Edge. This can scratch the knife blade if it comes
into contact with it when sharpening. We therefore recommend keeping
the guiding slot clean with a non-abrasive, dry towel. Clean the V-Edge's
housing as needed with a non-abrasive, dry or damp dishcloth and
a gentle detergent. No moisture should be allowed into the V-Edge's
interior.
Cleaning the interior
The dust that results from sharpening is extremely fine and doesn't usually
disrupt the sharpening process. Cleaning the V-Edge's interior is there-
fore unnecessary. However, should it become especially dirty, you can
loosen and remove the housing using a standard screwdriver. Once the
housing has been removed, the V-Edge can be carefully cleaned using
a dry brush or towel.
Not dishwasher-safe
■
Not water-resistant – please keep dry
■
IMPORTANT:
Reinigung Schleifleisten
Loosening the screws on the V-Edge and removing the housing
invalidates the statutory warranty.
38 |
ZWILLING V-Edge
Regular use will eventually wear down the sharpening surface. How-
ever, all four sides of the square sharpening rods can be used up to
100,000 times. Should advanced wear occur, you can simply turn the
sharpening rod 90° and use a different side.
If the sharpening stones demonstrate reduced performance, you can
simply rinse them under running water and clean them with a soft
sponge. Please do not use steel wool or similar implements.
The sharpening rods can be ordered with different grains for replace-
ment or to have as extra, as needed.
Four sides usable
| 39
ZWILLING V-Edge
Publicité
