Precor Vitality Serie Manuel De L'utilisateur page 59

Install the Weight Stack Assembly
1. Insert the guide rods into the holes at the bottom of the weight tower frame.
Important: A hole passes through one end of each guide rod. Be sure to insert the
end with the hole into the bottom of the frame.
2. Pull the guide rods away from the frame, keeping their lower ends engaged
in the bottom of the tower frame. Slide one weight stack bumper over each
guide rod, narrow end up.
3. Check the guide rods for silicone lubricant. If you do not find any, then add
some of the silicone lubricant supplied in the hardware kit, to the guide rods.
4. Carefully slide fourteen 15 lb (7 kg) weight plates onto the guide rods, one
by one.
5. Slide the top weight plate with weight stack stem onto the two guide rods
and lower the stem through the center holes of the weight plates.
6. Slide the ring at the end of the tether on the weight selection pin over the
right-hand post on the top weight plate.
7. Secure the weight stack assembly to the weight tower frame. Slide the guide
rod locking collars onto the guide rods with the narrow shoulders facing up.
Re-align the guide rods with the mounting holes at the top of the weight
tower.
8. While your assistant holds the guide rods in place, slide the collars up so the
shoulder of each collar fits securely into the tower frame. Secure the collars
to the guide rods by tightening the M8 set screws using the S4 hex key.
9. Apply the weight plate labels (select LBs or KGs) to the right of the weight
selection holes.
Vitality Series Selectorized Line Pulldown Assembly Guide: Assemble the Equipment
Figure 4: Weight stack installation
5