Publicité
To assemble the hand blender
WARNING! RISK OF INJURY!
►
The blade is extremely sharp! Handle it with great care at all times .
■
Place the hand blender 5 on the motor unit 4 so that the arrow points to
the symbol
points to the symbol
Assembling the wire whisk
■
Press the whisk 7 into the whisk holder 6, until it firmly engages .
■
Place the so assembled whisk 7 onto the motor block 4 so that the arrow
points to the symbol
symbol
Operation
WARNING! RISK OF INJURY!
►
Foodstuffs should not be too hot . Squirting contents may cause scalding .
NOTICE
►
When you beat cream with the whisk 7 hold the container at a slant during
the beating . In this way the cream will be thicker quicker . Ensure that cream
cannot be sprayed out of the container while it is being beaten . When
whipping cream, slide the speed regulator 1 to position "Max" .
When you have assembled the blender set as you wish to use it:
1) Insert the plug into a mains power socket .
2) Press and hold the switch
Slide the speed regulator 1 in the direction of "Max" to increase the speed .
Slide the speed regulator 1 in the direction of "Min" to reduce the speed .
3) Press and hold the turbo-switch 3 to process foodstuffs at a higher speed .
By pressing the turbo-switch 3 the maximum processing speed is available
immediately .
4) Once you are done processing the food, simply release the pressed switch
SSMS 600 E5
. Turn the hand blender 5 until the arrow on the motor unit 4
.
Turn the motor block 4 until the arrow points at the
.
2/3 .
2 to process foodstuffs at the standard speed .
GB │ IE
│
7
■
Publicité
