Publicité
Steam Clean
The Steam Clean feature ofers a chemical free and
time saving method to assist in the routine clean-
ing of small and light soils. For heavier baked on
soils use the Self Clean feature.
CAUTION
Do not add bleach, ammonia, oven cleaner, or
any other abrasive household cleaners to the wa-
ter used for Steam Clean.
Before cleaning any part of the oven, be sure all
controls are turned of and the oven is cool. The
oven may be hot and can cause burns.
To set a steam clean cycle:
1.
Remove all racks and oven accessories.
2. Scrape or wipe loose debris and grease from
the oven bottom.
3. Push in and turn the Oven Mode knob to
CLEAN MODES. CLn will show in the tempera-
ture display, and the SELECT MODE indicator
will come on.
4. Turn the Oven Temperature knob to STEAM
CLEAN. The display will show Add H2o. The
DOOR indicator will come on.
5. Open the oven door and add 1 cup of water
to the bottom of the oven. The CLOSE DOOR
indicator will come on.
Figure 14: Add 1 cup of water
6. Close the oven door. The Steam Clean cycle will
begin, and the timer will count down.
7.
When the cycle ends, the display will continue
to show oFF.
To end the Self Clean cycle at any time, turn the
Mode knob to OFF.
SETTING OVEN CONTROLS
Delay Start
You can set a delayed start time for the following
functions: bake, convection bake, convection roast,
no preheat, air fry, steam bake, steam roast, steam
clean, and self clean.
The maximum delay time for self clean or steam
clean is one hour.
To set a delayed start:
1.
Press and hold the light key for 3 seconds to
access the Settings menu.
2. Use the + and - keys on the left to select the
delay start function (dLY).
3. Use the + and - keys on the right to specify the
delay time.
4. Press and hold the light key for 3 seconds to
conirm the delay time.
5. Use the Mode and Temp dials to select the
function to start and temperature.
6. The display will show the countdown time until
cooking starts.
39
Publicité
