Publicité
14
BEFORE SETTING SURFACE CONTROLS
Gas surface burner types
The cooktop is equipped with gas surface burners
with diferent BTU ratings. The ability to heat food
quickly and in large amounts increases as the burn-
er size increases.
•
Small burners are best used for low-flame heat-
ing of small amounts of food.
•
Standard burners can be used for most surface
cooking needs.
•
The largest burner is best used for bringing
large quantities of liquid rapidly up to tem-
perature or when preparing larger quantities
of food. The large burner is located at the right
front position on the cooktop.
Regardless of size, always select cookware that
is suitable for the amount and type of food being
prepared. Select a burner and set the flame size
appropriately for the pan. Never allow flames to
extend beyond the outer edge of the pan.
Burner Cap
Burner Head
Orifice Holder
Ignitor
Figure 1: Burner cap, burner head, ignitor, and
orifice
Assembly of the Burner Caps
Make sure that all of the surface burner caps and
surface burner grates are installed correctly and at
the correct locations.
1.
Remove all packing material from the cooktop
area.
2. Make sure burner head and caps are properly
placed on the surface burners.
Important: The burner head has a hole which its
over the ignitor. Make sure the head its snugly be-
fore placing the burner caps.
Note: Unpack the burner grates and position them
on the cooktop after the burner heads and caps are
properly installed.
CAUTION
•
Do not allow spills, food, cleaning agents, or
any other material to enter the gas oriice
holder opening.
•
Always keep the burner caps and burner
heads in place whenever the surface burners
are in use.
•
Never place lammable items on the cooktop.
Publicité
