Publicité
Cleaning the sealed burners
To avoid possible burns, do not attempt cleaning
before turning of all surface burners and allowing
them to cool.
Any additions, changes, or conversions required in
order for this appliance to satisfactorily meet the
application needs must be made by an authorized
qualiied Agency. Routinely clean the cooktop.
Wipe with a clean, damp cloth and wipe dry to
avoid scratches. Keeping the surface burner head
ports and slots clean will prevent improper ignition
and an uneven flame.
To clean recessed and contoured areas of cooktop:
•
If a spill occurs on or in the recessed or con-
toured areas, blot up spill with an absorbent
cloth.
•
Rinse with a clean, damp cloth and wipe dry.
CAUTION
To avoid possible burns do not attempt to oper-
ate the surface burners without the burner caps.
Do not use spray oven cleaner on the cooktop.
To clean burner heads:
1.
Remove the burner cap and burner head (see
Figure 16). Clean the cap and head with hot
soapy water and dry thoroughly.
2. For burned-on and dried spills, apply hot soapy
water to the burner cap and head to allow time
for the soils to soften.
3. Use a toothbrush to clean all over the burner
head.
4. Wipe the burner cap and head clean with a
soft, clean cloth, sponge, or scratch-free clean-
ing pad. Wipe out burner orii ce with a cloth
before placing burner head and cap back on.
The burner assembly must be completely dry
before use.
5. Make sure the burner caps and heads are
placed and seated properly over the ignitor.
The three mounting legs on burner will align
with slots on the orii ce holder. When placed
correctly, the burner cap should not move of
the burner head (see "Assembly of the Burner
Caps" on page 14).
6. If burner fails to light, recheck placement of
burner head to the orii ce holder and cap.
CARE AND CLEANING
Burner Cap
Burner Head
Orifice Holder
Ignitor
Figure 16: Removeable burner components
Important notes:
•
Always keep the surface burner caps in place
whenever a surface burner is in use.
•
When replacing the burner caps, be sure the
burner caps are seated i rmly on top of the
burner heads.
•
For proper fl ow of gas and ignition of burners
do not allow spills, food, cleaning agents, or
any other material to enter the gas orii ce port
opening.
43
Publicité
