Wolf ICBIR36550/S/T Guide D'utilisation Et D'entretien page 6

Induction Range Features
Induction Range Features
FEATURES
1
Product Rating Plate
2
Touchscreen
3 Convection Oven
4 Rangetop Control Panel
5
Induction Element
6
Bridge Element
5 6
4
3
914 mm Induction Range shown
6 | English
Getting Started
We know you are eager to start cooking, but before you
do, please take some time to read this use and care guide.
Whether you are an occasional cook or an expert chef, it
will be to your benefit to familiarize yourself with the safety
practices, features, operation, and care recommendations
of your Wolf Induction Range.
In induction cooking, the electricity flows through a coil to
produce a magnetic field under the glass-ceramic surface.
When an induction-compatible pan is placed on the cook-
ing surface, currents are induced in the pan and instant
heat is generated. Cookware made of magnetic materials,
such as cast iron or magnetic stainless steel, is required for
induction cooking.
To ensure all residual oil from the manufacturing process
has been removed, clean the range thoroughly with hot
water and mild detergent prior to use. Rinse and dry with a
2
soft cloth. Refer to Care Recommendations on page 13.
1
To ensure the best results, review the cooking modes and
special features on page 9.
CAUTION
Do not place cookware on the oven floor or use
aluminum foil or other material to line the oven
floor or side walls. Failure to adhere to this notice
will damage the porcelain interior and will void your
warranty.
INDUCTION ELEMENT RATING
762 mm RANGE
279 mm
(2) 203 mm with bridge
152 mm
914 mm RANGE
279 mm
(2) 203 mm with bridge
(2) 203 mm with bridge
Oven Operation
Oven Racks
OVEN RACK GUIDES
To install the rack guides in the oven, locate the mount-
ing screws on the oven side walls. Place the rack guide
mounting tabs over the top screws, pivot inward, and slide
down until fully seated. Refer to the illustration below.
OVEN RACKS
To insert a standard rack in the oven, place the rack anti-tip
lock under the side rack guide rails. Slide the rack back
and lift up to clear the rack stops. Continue to slide the
rack back until completely inside the oven. Refer to the
illustration below.
MOUNTING
TAB
Oven rack guide Oven rack anti-tip lock
kW
2.6/3.7 boost
2.1/3.7 boost
1.4/3.7 boost
kW
2.6/3.7 boost
2.1/3.7 boost
2.1/3.7 boost
To insert a full-extension rack, place the two rear tabs onto
the rack guide (one tab above and one below). Refer to
the illustration below. Angle the rack slightly and slide back
until the front rack notch engages the front rack guide.
REAR TAB
Full-extension rack
RACK
STOP
ANTI-TIP
LOCK