Bosch MS 200 Notice D'installation page 30

Installation
3.2.3 Wiring diagrams with unit examples
The hydraulic diagrams are only schematic illustrations and provide a
non-binding indication of a possible hydraulic circuit. Install safety
equipment in accordance with applicable standards and local
regulations. For further information and options, refer to the technical
guides or tender specification.
Solar systems
You will find the required connections for MS 200, and, if applicable, at
MS 100 and the corresponding hydraulics diagrams for these examples
are presented in the appendix.
The designation of the wiring diagram to the solar system can be made
easier by answering the following questions:
• Which solar thermal system
• Which functions (shown in black) are available?
• Are additional functions
system can be expanded with the additional functions (shown in grey).
An example of the configuration of a solar system is included in these
instructions as a part of commissioning.
You can find a description of the solar thermal systems and functions
more towards the beginning of this document.
30
is available?
available? The previously selected solar
Solar system MS 200 MS 100
1 A –
1 A GHK
1 AE GH
1 B AGHKP
1 BD GHK
1 BDF GH
1 C DHK
1 ACE HP
1 BDI GHK
1 BDFI GHK
1 AJ BKP
1 AEJ BP
1 ABEJ GKMP
1 ACEJ KMP
1 BDNP HK
1 BNFNP H
1 BNFNP GHKM
1 BNQ –
1 ... ... K
1 ... ... L
Table 7 Examples often with realized solar systems
(note limitations in combination with the interface of a heating
pump (HPC 400/HPC 410/HMC300/HMC310))
Solar thermal system
Solar function
Additional function (shown in grey)
A Central heating backup (
B 2rd cylinder with valve
C 2nd cylinder with pump
D Central heating backup 2 cylinder (
E External heat exchanger at cylinder 1
F External heat exchanger at cylinder 2
G 2nd collector array
H Return temperature control (
I Transfer system
J Transfer system with heat exchanger
K Thermal disinfection
L Heat meter
M Temp. differential controller
N 3rd cylinder with valve
P Pool
Q External heat exchanger at cylinder 3
Wiring diagram at
the end of the
document
  1A
–
  1A (GHK)
–
  1AE (GH)
–
  1B (AGHKP)
–
  1BD (GHK)
–
  1BDF (GH)
–
  1C (DHK)
–
  1ACE (HP)
–
  1BDI (GHK)
–
   1BDFI (GHK)
  1AJ (BKP)
–
  1AEJ (BP)
–
   1ABEJ (GKMP)
   1ACEJ (KMP)
  1BDNP (HK)
–
  1BDFNP (H)
–
   1BDFNP (GHKM)
  1BNQ
–
  1... (K)
–
  1... (L)
–
)
)
)
MS 200 – 6721819173 (2020/02)