Dräger HPS SafeGuard NFPA Notice D'utilisation page 5

– All other tasks that are included in the remit of a fire
fighter, with the exception of riding a motorbike.
All other applications are excluded.
The fire helmets protect the wearer's face and head against:
– Impacts
– Sharp objects
– Impact from solid objects
– Contact with liquids, corrosive chemical substances, and
molten metals
– Radiant heat
– Flames
– Contact with electric current
3.4 Approvals
The helmet meets the requirements of the following
standards:
– NFPA 1971:2018
– NFPA 1951:2020
3.5 Explanation of type-identifying
marking and symbols
The type designation is found on the packaging label and on
the individual components.
3.5.1 Marking of the helmet
1 2 3
D ST
Typ A3b
Size
5 0 -6 7cm
NFPA 1971, 2018 ED
NFPA 1951, 2020 ED
Made in
Czech Republic
1 Various markings (see following table)
2 Serial number
3 Accredited certification body
4 Type of helmet
5 Date of manufacture
6 Manufacturer
7 Standards which must be met for approval
Marking Explanation of marking
DST Manufacturer abbreviation
Dräger Safety AG & Co. KGaA
A3b Type: Three-quarter shell helmet
50 - 67 Head circumference in cm
Symbol for "See instructions for use"
Instructions for use | Dräger HPS SafeGuard
4
HPS SafeGuard
Revalstraße 1,
D-23560 Lübeck, Germany
7 6
3.5.2 Marking of the visors
The marking is engraved into the visor and shown on a label.
It displays the following:
Marking
Z87+
EN 14458:2018
UL
NFPA 1971, 2018 ED
4 Use
4.1 Requirements for use
– The fire helmet must be used in accordance with the
NFPA 1500 and 29 CFR 1910.132, General Requirements
of Subpart I, Personal Protective Equipment.
– Check whether the helmet is suitable for the conditions
presented by the respective operation, as suitability must
be determined before the helmet is in use.
– The helmet must be clean and dry.
4.2 Preparation for use
To identify the helmet, write the name on the label inside the
helmet using a waterproof pen before first use.
5
The support ring must be adjusted to ensure the fire helmet is
a correct fit.
The harness and support ring must be adjusted to the head
size when in daily use.
WARNING
An incorrectly adjusted helmet can cause an injury.
The protective function of the fire helmet can only be achieved
when the fire helmet fits perfectly.
► Correctly adjust the harness and the support ring.
► Correctly secure all attachments to the fire helmet.
The following preparations are optional:
– Attach the lamp holder for the standard helmet lamp
– Attach the Dräger HPS BuddyLight
Explanation of marking
ANSI/ISEA Z87.1-2020 approved
European standard for eye and face protectionl
Accredited certification body
American standard which must be met for approval
| en
Use
5