Dräger HPS SafeGuard NFPA Notice D'utilisation page 16

en |
Maintenance
3. Undo the hook-and-loop fastener on the front support ring
and remove the support ring.
4. Secure the new front support ring to the front adjusting
ring.
5. Thread the hook-and-loop fastener through the loops of
the front support ring and close them.
16
6. Secure the front support ring to the rear support ring.
5.2.5.5 Replacing the rear head padding
Spare parts required:
– Rear head padding 3701614
1. Adjust the support ring to a medium size using the
adjusting wheel. Remove the rear head padding from the
helmet by pulling it from the rear support ring.
2. Adjust the support ring to a medium size using the
adjusting wheel to ensure the holes, into which the rear
head padding is inserted, are open.
Instructions for use | Dräger HPS SafeGuard