Publicité
Les langues disponibles
Les langues disponibles
en
|
Maintenance
5.2.5 Complete removal of internal helmet
components
1. Undo the top section of the clip bracket from the rear
adjusting ring.
2. Pull the harness from the three slot holes.
10
3. Adjust the support ring to a medium size using the
adjusting wheel. Remove the rear head padding from the
helmet by pulling it from the rear support ring.
4. Slide the front and rear support rings against each other in
the slot holes and separate them.
There is a slot hole in the front adjusting ring. The front
support ring is engaged with this slot hole. To release it,
the front support ring must be pulled from the helmet shell.
5. Release the front support ring from the front adjusting ring.
The supporting arms of the front adjusting ring have slot
holes into which the rear support ring can be inserted.
Instructions for use
|
Dräger HPS SafeGuard
Publicité
