Publicité
Les langues disponibles
Les langues disponibles
en
|
Maintenance
12. Feed the hook-and-loop straps through the front adjusting
ring and the loops of the front support ring and close them.
13. Secure the front support ring to the rear support ring.
14. Secure the harness at the front and rear adjusting rings.
The clip bracket on the rear adjusting ring must be
released.
14
15. Push the upper section of the clip bracket all the way into
the rear adjusting ring such that the harness is fastened.
16. Adjust the rear head padding and secure at the rear
support ring.
5.2.5.2 Replacing the harness
Spare parts required:
– Harness 3701665
1. Pull the harness from the three slot holes.
Instructions for use
|
Dräger HPS SafeGuard
Publicité
