ST BP 375 Manuel D'utilisation page 126

Before starting to use the machine again:
1. Arrange the machine (chap. 6)
10. HANDLING AND TRANSPORTATION
Whenever the machine is to be
handled or transported you must:
– Stop the machine (par. 6.5).
– Wait until the rotor is stationary.
– Remove the spark plug cap (Fig. 9.G).
– Only hold the machine using the
handgrips and position the tubes
so that they do not obstruct.
When transporting the machine
on a vehicle, always:
– remove the tubes;
– fasten the machine securely
with cables or chains;
– position it so that it can not cause
a hazard for anybody.
11. ASSISTANCE AND REPAIRS
This manual provides all the necessary
information to run the machine and for correct
basic maintenance operations which can
be performed by the user. Any regulations
and maintenance operations not described
herein must be carried out by your Dealer
or Authorised Service Centre, which have
the necessary knowledge and equipment to
ensure that the work is carried out correctly,
maintaining the correct degree of safety and the
original operating conditions of the machine.
Any operations performed in unauthorised
centres or by unqualified persons will totally
invalidate the Warranty and all obligations
and responsibilities of the Manufacturer.
13. MAINTENANCE TABLE
Intervention
MACHINE
Check all fasteners
Safety checks/check controls
General cleaning and inspection
ENGINE
Checking/topping up fuel level
General cleaning and inspection
• Only authorised service workshops can carry
out guaranteed repairs and maintenance.
• The authorised service workshops
only use genuine spare parts. Genuine
spare parts and accessories have been
designed specifically for machines.
• Genuine spare parts and accessories have
been designed specifically for machines.
• Non-original parts and attachments are
not approved; use of non-original spare
parts and attachments will jeopardise
the safety of the machine and relieve the
Manufacturer from all obligations or liabilities.
• It is advisable to send your machine
once a year to an authorised service
workshop for servicing, assistance
and safety device inspection.
12. WARRANTY COVERAGE
The warranty covers all material and
manufacturing defects. The user must
follow all the instructions provided in
the accompanying documentation.
The warranty does not cover
damages caused by:
• Failure to become familiar with the
documentation accompanying the machine.
• Carelessness.
• Incorrect or prohibited use or assembly.
• Use of non-genuine spare parts.
• Use of accessories not supplied or
approved by the manufacturer.
The warranty does not cover:
• Normal wear of consumable materials.
• Normal wear and tear.
The purchaser is protected by his or her own
national legislation. The purchaser's rights under
the national laws or his or her own country are
not in any way restricted by this warranty.
Frequency
Before each use
Before each use
After each use
Before each use
After each use
EN - 12
Paragraph
7.5
6.2
7.4
7.3
7.4