Monogram ZIC363NBVRH Instructions D'installation page 68

Installation Instructions - Door Panels - French Door Models
STEP 2 PANEL INSTALL & ADJUSTMENT (Cont.)
8. Repeat steps 3-7 for the convertible drawer.
9. Repeat steps 3-7 for the freezer drawer.
10. Tighten all screws once you are satisfied with the
panel alignment.
11. Install bottom H1 and J1 brackets.
For Stainless Steel Panels: Use the M4 machine
screws provided with the stainless steel panel kit.
Use a small washer with each screw and a H1/J1
Shim. Both are provided with the refrigerator.
For Custom Panels: Use #6 phillips head wood
screws and small washers provided with refrigerator.
H1/J1 shim is not required.
J1 H1
D1
G1
E1
H1 J1
French Doors -
Back View of Panels
12. Install G1 brackets on back side of refrigerator panel.
For Stainless Steel Panels: Use the M4 machine
screws provided with the stainless steel panel kit.
For Custom Panels: Use #6 phillips head wood
screws provided with refrigerator.
J1
D1
G1
E1
H1
A1
H1/J1 Shim - Stainless
Steel Panels only
G1
B1
H1
A1
G1
G1
B1
J1
13. Custom Panels only: For panels with minimum of
3" styles and rails an extra hole must be drilled into
the top H1 and J1 brackets after panels are adjusted
to lock down the panel in its final position.
14. Before installing trims, inspect bracket tabs to verify
they are not bent. Tabs must be parallel to the panel
in order to properly install the trims.
X
15. Clip trim onto brackets to hide the panel adjustment
hardware.
16. Add trim caps to cover the ends of the trim.
NOTE: If trim caps are not flush with the top of the
door, hold the top and bottom caps when adjusting
the trim up or down so that the caps do not come
loose. Make sure the caps are flush to the trims after
adjustment.
68 31-1000708 Rev. 4