Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions - Dual Standard Installation
STEP 4 INSTALL ANTI-TIP BRACKETS
WARNING
These appliances are top heavy, especially with any
doors open, and must be secured to prevent tipping
forward which could result in death or serious injury.
Read and follow the entire installation instructions
for securing the appliance with the anti-tip system.
AVERTISSEMENT
basculement.
Ces électroménagers sont lourds du
haut, notamment lorsqu'une porte est ouverte, de sorte
qu'ils doivent être fixés pour prévenir un basculement
vers l'avant susceptible d'occasionner des blessures
graves ou la mort. Lisez et observez la totalité des
instructions d'installation pour connaître la façon de fixer
l'électroménager sur le dispositif antibasculement.
ADVERTENCIA
Caídas
Estos electrodomésticos son inestables, espe-
cialmente cuando una puerta se encuentre abierta, y
deben estar asegurados a fin de evitar caídas hacia
adelante que podrían resultar en la muerte o en lesiones
graves. Lea y siga las instrucciones de instalación en su
totalidad para asegurar el electrodoméstico con el sistema
anti volcaduras.
Remove the anti-tip bracket(s) from the hardware kit.
Secure anti-tip brackets to the floor so that the back
side of the anti-tip bracket is 22 5/8" (57.5 cm) from the
front of the enclosure (bracket hardware is provided for
mounting into wood and concrete).
Measure and mark from the right side of the opening
per the dimensions shown.
65-1/2" (166.4 cm)
Tip Over Hazard.
Risque de
Riesgo de
6" (15.2 cm)
29-3/4" (75.6 cm)
41-1/2" (105.4 cm)
Mount the anti-tip bracket centered about the marks
and flush to the floor as shown. Mark 3 holes for wall
mounting or 4 holes for floor mounting.
WOOD MOUNTING: Predrill with 3/16" drill bit, 2" deep,
then install provided lag bolts with a 3/8" driver.
CONCRETE MOUNTING: Predrill with a 5/32" concrete
bit, 2" deep, then install provided tapcon screws with a
5/16" driver.
NOTE: For substrates not listed above, contact a
licensed contractor to determine the appropriate
hardware.
The bracket must be screwed to either the FLOOR or
REAR WALL.
Tape the waterline to the wall and floor as shown
below. Waterline should be 10" (25.4 cm) away from
adjacent wall. Apply tape about every 5" (12.7 cm)
toward front of
unit. This will keep the waterline away from the
anti-tip bracket(s) and prevent the unit from rolling over
the waterline during installation. Do not tape near the
cabinet front in order to keep tape hidden under
the unit.
5"
10"
36
5"
10"
31-1000708 Rev. 4
Publicité
