Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions - Single Integrated Installation
STEP 1 REMOVE PACKAGING
WARNING
These appliances are top heavy, especially with any
doors open, and must be secured to prevent tipping
forward which could result in death or serious injury.
AVERTISSEMENT
basculement.
Cet électroménager est lourd du haut.
Usez d'extrême prudence en le déplaçant afin de prévenir
un basculement susceptible d'occasionner des blessures
graves ou la mort.
ADVERTENCIA
Este electrodoméstico es inestable. Tenga extremo
cuidado al moverlo, a fin de evitar caídas hacia adelante
que podrían resultar en la muerte o lesiones graves.
Remove outer carton and external packing from units.
There is a box of parts taped to the outside of the
refrigerator. These parts will be used during the door
panel and toe kick installation.
Inspect for damage.
Ensure the flooring that the units are set is clean/
free of debris that could be collected on to, or
pinched in front of the wheels and damaging the
floor. Additionally, it is recommended that the floor
be protected with a plastic covering through out the
installation process.
Tip Over Hazard.
Risque de
Riesgo de Caída.
Remove hardware kits that are located inside the unit.
Remove front access cover from unit by removing two
1/4" hex head screws. Place the cover and screws to
the side for future
installation.
Remove two 3/8" drive screws and two 7/16" drive
screws from each side of the unit to release it from
the shipping skid. Tip the unit from the side enough to
remove the shipping material from under the unit, but
above the shipping skid (both sides)
CAREFULLY roll the unit off the back side of the ship-
ping skid.
Handle from side only with a hand truck.
3/8" Drive
Screws
Shipping
Bracket
7/16" Drive
Screws
Access
Cover
22
1/4" Hex Head
Screws
31-1000708 Rev. 4
Publicité
