Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions - Dual Integrated Installation
STEP 11 INTERNAL UNIT
PREPARATION
Remove all tape, cardboard, and foam from each
unit.
Remove boxed door bins from shelves.
Unbox and install door bins.
Install door bin mats (some models).
Install Odor filter and Fresh filter (some models). See
Owner's Manual for details
STEP 12 START ICEMAKER
CAUTION
To minimize the risk of personal
injury, avoid contact with the moving parts of the
ejector mechanism, or with the heating element that
releases the cubes. Do not place fingers or hands on
the automatic ice making mechanism while the
appliance is plugged in.
ATTENTION
Afin de réduire le risque de blessure,
évitez tout contact avec les pièces mobiles du mécanisme
d'éjection ou l'élément chauffant qui libère les cubes. Ne
placez pas les doigts ou les mains sur le mécanisme de
production de glace automatique lorsque l'électroménager
est branché dans la prise électrique.
PRECAUCIÓN
lesiones personales, evite el contacto con las partes móviles
del mecanismo eyector o con el elemento de calefacción
que libera los cubos. No coloque los dedos ni las manos en
el mecanismo de la máquina de hielo automática mientras el
electrodoméstico se encuentre enchufado.
A newly-installed freezer may take 12–24 hours to
begin making ice.
The icemaker will produce seven cubes per cycle—
approximately 15 cycles in a 24-hour period,
depending on freezer compartment temperature, room
temperature, number of door openings and other use
conditions.
If the freezer is operated before the water connection
is made to the icemaker, turn the ice maker off by
pressing and holding the Zone Select pad until Ice Off
appears.
Para minimizar el riesgo de
STEP 12 START ICEMAKER
When water has been connected to the water supply,
turn the ice maker on by pressing and holding the
Zone Select pad until Ice On appears.
Throw away the first full bucket of ice to allow the water
line to clear.
Be sure nothing interferes with the sweep of the feeler arm.
(Appearance may vary)
When the bin fills to the level of the feeler arm, the
icemaker will stop producing ice.
It is normal for several cubes to be joined together.
If ice is not used frequently, old ice cubes will become
cloudy, taste stale and shrink.
NOTE: Icemaker works best between 40 and 120 PSI
(275-827 kPa) home water pressure.
58
Icemaker
Feeler Arm
31-1000708 Rev. 4
Publicité
