Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions - Single Integrated Installation
STEP 7 FINAL EXTERNAL UNIT
PREPARATION (Cont.)
Locate blue arrow on
align arrow as shown.
removal tool if needed).
mounting hook.
Close the compartment door.
Put the access cover back onto the
unit and secure with two 1/4" hex
head screws.
Access
Cover
If installation requires a
limiter pin(s) must be installed
BEFORE the unit is removed from the shipping skid.
Pin is located in the hardware kit.
- Open the door to expose the hole in the back hinge
bracket and install the limiting pin. Pin must be
fully seated in the hinge or the door will not close
properly.
1/4" Hex
Screws
90°
door opening, the hinge
in the top hinge(s)
STEP 8 TOE KICK INSTALLATION
Create a custom toe kick or use the stainless steel
toe kick that is provided with the Stainless Steel Door
Panel Kit (sold separately).
The toe kick attaches to the refrigerator by using a
magnet that can be found in the box of parts that was
taped to the side of the unit.
Adhere magnet to back side of toe kick. The surface
of the toe kick where the magnet is to be placed
must be clean and free of foreign material. Center
magnet vertically and horizontally.
Position toe kick on bottom portion of the front
access cover.
Single Integrated Custom Toe Kick Dimensions
Thickness
No greater than 3/4" (1.9 cm)
Width
35 7/8" (91.1 cm)
Height
Determine after product is leveled in
installation space
STEP 9 INTERNAL UNIT
PREPARATION
Remove all tape, cardboard, and foam from the unit.
Remove boxed door bins from shelves.
Unbox and install door bins.
Install door bin mats (some models).
Install Odor filter and Fresh filter (some models). See
Owner's Manual for details.
28
31-1000708 Rev. 4
Publicité
