Monogram ZIC363NBVRH Instructions D'installation page 43

Installation Instructions - Dual Standard Installation
STEP 11 FINAL EXTERNAL UNIT PREPARATION (Cont.)
Put the access cover back onto the unit and secure with
two 1/4" hex head screws.
Access
Cover
of the installation, drive two 1/4" hex head screws.
These screws will enhance attachment of mullion trim.
Repeat on the second access cover.
Access Cover
Hole Locations
Mullion Trim Installation
Open all doors and drawers.
the dart in the area between the units.
necessary.
31-1000708 Rev. 4
1/4" Hex
Screws
Open both water filter
access doors to 90°.
Snap the trim
bracket between the
water filter access
enclosures above
displays.
If installation requires
a
the hinge limiter pin(s)
must be installed
- Open the door to expose the hole in the back hinge
43
90° door opening,
in the top
bracket and install the limiting pin. Pin must be fully
seated in the hinge or the door will not close properly.
Mullion
Trim
"Dart"
NOTE: Doors/Drawers not
shown for clarity.
hinge(s).