Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions - Dual Standard Installation
STEP 6 CHANGE POWER CORD
If your electrical outlet location requires a longer power
cord, follow the instructions below to change to the longer
power cord provided with the standard install kit.
Remove existing short power cord with string
assembly:
Remove 1/4" hex screws attaching rear access cover.
1. Unplug 3-pin power cord connector inside the
machine compartment (press on sides to release
locking tabs).
2. Remove power cord green ground 1/4" hex screw.
3. Remove strain relief 1/4" hex screw.
4. Remove string from short power cord by cutting
the string near the wire tie.
Step 2
Green Ground
Screw
Step 3
Strain Relief
Screw
Install new longer power cord:
1. Tie string around longer power
cord 18 inches from strain relief
and put wire tie on as shown.
2. Plug in the 3-pin connector (make
sure locking tabs are engaged).
3. Install the power cord green
ground screw.
4. Install the power cord strain relief.
Note: Do not over tighten wire tie.
Over tightening could cause damage
to power cord.
Step 1
3-Pin
Power Cord
Connector
3-Pin
Power Cord
Connector
Rear
Access
Cover
STEP 6 CHANGE POWER CORD
(Cont.)
WARNING
Death or serious injury can result from failure to follow
these instructions.
• Service by a qualified service technician only.
• Disconnect power before servicing this product.
• Reconnect all grounding devices after service.
• Replace all parts and panels before operating.
AVERTISSEMENT
d'électrocution.
peut occasionner des blessures graves ou mortelles.
• L'entretien et la réparation du produit doivent être effectués
par un technicien qualifié seulement.
• Débranchez l'alimentation électrique avant d'entretenir ou
de réparer ce produit.
• Rebranchez tous les dispositifs de mise à la terre après
l'entretien ou la réparation.
• Remettez en place toutes les pièces et tous les panneaux
avant l'utilisation
ADVERTENCIA
Eléctrica
Se podrá producir la muerte o daños graves
como resultado de no seguir estas instrucciones.
• El servicio técnico deberá ser realizado por un técnico
calificado del servicio únicamente.
• Desconecte el cable de corriente antes de realizar el servicio
técnico de este producto.
• Vuelva a conectar todos los dispositivos de conexión a tierra
luego de realizar el servicio técnico.
• Vuelva a colocar todas las piezas y paneles antes del uso.
Replace rear access cover. Make sure the power
cord
is
properly routed through the access cover
cut-out.
STEP 7 CASE TRIM INSTALLATION
Install the trim kit side
rails to the exposed
right and
left case walls using
the provided #8
Phillips head screws -
8
screws per side.
38
Electrical Shock Hazard.
Risque
L'omission d'observer ces instructions
Riesgo de Descarga
31-1000708 Rev. 4
Publicité
