Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions - Dual Integrated Installation
STEP 9 FINAL EXTERNAL UNIT
PREPARATION
FOR FLUSH INSTALLATION:
of the door is 3/4" behind front face of surrounding
cabinets BEFORE securing brackets to the surrounding
cabinetry.
Compartment Door
Open the doors to
Filter Removal
the units. Locate
Tool
removal tool. Filter
should be as shown.
counterclockwise
needed).
remove. NOTE: Water
system will not function
Predrill 1/16" holes is both the sides of the surround
1/2" deep through holes in the enclosure.
Secure unit to surrounding cabinetry using the spacers
and 1" Phillips screws provided with the unit.
In some models the spacer comes with a double-
sided tape. Peel off the tape and stick the spacer
onto the unit by aligning the holes on the
Push the unit into the enclosure and drive the Phillips
head screws thru the
A
cabinetry.
In some models the spacer comes without a double-
sided tape. These spacers come with aligning features.
Push the unit into the enclosure. Slide the spacers into
place using the alignment features on the spacer and
the side of the housing until the spacer screw holes
and housing screw holes are aligned. Drive the Phillips
head screws thru the housing into the surrounding
cabinetry.
NOTE: This step does NOT replace the anti-tip safety
hardware. Refer to Step 3 Installing Anti-Tip Bracket and
Step 5 Inserting / Securing into Cabinet Surround for
details on installing the anti-tip hardware.
Housing
A
Locating feature
on the housing
Make sure front surface
Filter
Mounting Hook
A
housing.
housing into the surrounding
Locating feature
on the spacer
Cabinet
A
Spacer
STEP 9 FINAL EXTERNAL UNIT
PREPARATION (Cont.)
Locate blue arrow on
align arrow as shown.
removal tool if needed).
mounting hook.
Close the compartment door.
Put the access cover back onto the
unit and secure with two 1/4" hex
head screws.
Access
Cover
On the side of the access cover that will face the middle
of the installation, drive two 1/4" hex head screws. These
screws will enhance attachment of mullion trim. Repeat
on the second access cover.
Access Cover
Hole Locations
56
1/4" Hex
Screws
31-1000708 Rev. 4
Publicité
