Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions - Single Integrated Installation
STEP 6 LEVEL UNIT
All models have 4-point leveling. The front is supported
by leveling legs; the rear is supported by adjustable
wheels. Both are accessible from the front of the unit.
To level the back of the unit, turn the 7/16" hex nut
located above the front leveling legs. Turn clockwise
to raise or counterclockwise to lower the unit.
leveling leg or a 7/16" open-end wrench at the bottom
of the leveling leg.
opening 84". The unit should be level and plumb with
cabinetry. The front wheels must be a minimum of
1/8" (0.3 cm) off the floor.
7/16" hex nut
adjusts rear
wheels
T30 bit
adjusts front
leveling legs
NOTICE: The rear leveling wheels and front leveling
legs are limited to a maximum height adjustment of 1".
If the installation requires more than 84" height, the
installer should elevate the unit on a sheet of plywood
or runners. Cabinetry trim could also be added across
the top of the opening to shorten the opening. If you
attempt to raise the unit more than 1", you will damage
the front leveling legs and the rear leveling wheels.
31-1000708 Rev. 4
7/16" open end wrench
adjusts front leveling legs
STEP 7 FINAL EXTERNAL UNIT
PREPARATION
FOR FLUSH INSTALLATION:
of the door is 3/4" behind front face of surrounding
cabinets BEFORE securing brackets to the surrounding
cabinetry.
Open the doors to
the units. Locate
removal tool. Filter
should be as shown.
counterclockwise
tool if needed).
remove. NOTE: Water
system will not function
Predrill 1/16" holes is both the sides of the surround
1/2" deep through holes in the enclosure.
Secure unit to surrounding cabinetry using the spacers
and 1" Phillips screws provided with the unit.
In some models the spacer comes with a double-
sided tape. Peel off the tape and stick the spacer
onto the unit by aligning the holes on the
Push the unit into the enclosure and drive the Phillips
head screws thru the
cabinetry.
In some models the spacer comes without a double-
sided tape. These spacers come with aligning features.
Push the unit into the enclosure. Slide the spacers into
place using the alignment features on the spacer and
the side of the housing until the spacer screw holes
and housing screw holes are aligned. Drive the Phillips
head screws thru the housing into the surrounding
cabinetry.
NOTE: This step does NOT replace the anti-tip safety
hardware. Refer to Step 3 Installing Anti-Tip Bracket and
Step 5 Inserting / Securing into Cabinet Surround for
details on installing the anti-tip hardware.
Housing
A
Locating feature
on the housing
27
Make sure front surface
Compartment Door
Filter
Filter Removal
Tool
Mounting Hook
A
housing.
housing into the surrounding
A
Locating feature
on the spacer
Cabinet
A
Spacer
Publicité
