Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions - Dual Integrated Installation
STEP 3 PREPARING UNIT FOR INSTALLATION
Unpack the heater Unification Kit (ZKMV) and make
sure all of the components on the list are included.
NOTE: Ensure the heater connector cord is toward the
top of the unit when installed.
Place the right hand unit in front of the installation
opening in a way that the unit is in front of the intended
installed location. Make sure unit remains unplugged
and off.
Install adhesive heater on the outside of the right hand
unit to the left side of the case. Install heater 4" below
the case top. Heater should be centered front to back
on the metal case.
Use clips to adhere loose wire tightly to side of case as
shown. Clean the side using rubbing alcohol to ensure
proper clip adhesion.
NOTE: The heater installation is available only on the left
side of compatible models.
4"
Adhesive
Heater
WARNING
Electrical Shock
Hazard.
To avoid the risk of electric shock, make
sure the power cord is not plugged into the wall outlet.
AVERTISSEMENT
d'électrocution.
Pour prévenir le risque
d'électrocution, assurez-vous que le cordon électrique
n'est pas branché dans la prise murale.
ADVERTENCIA
Si no se siguen estas instrucciones, se podrá producir
la muerte, incendios o descargas eléctricas.
Clips
Risque
Riesgo de Descarga
Install the transformer into the case top assembly:
1. Remove cover top by removing eight #8 hex screws
and keep aside for assembling back the cover top.
2. Place the transformer provided in ZKMV kit onto the
case top. Secure transformer with (1/4") hex screw to
case top in existing hole at the rear right side of the
top control housing.
3. Connect the 2 pin transformer connector to the heater
connector and 3 pin connector to panel control, make
sure locking tabs are engaged.
4. NOTE: Verify the master switch is on.
5. Assemble the cover top with screws save from
previous step.
Plug 2 position heater
connector to 2 position
transformer connector with
blue and yellow wires.
Control
Housing
Master Switch
Plug 3 position transformer connector with
black and white wires to 3 position harness
connector with brown and orange wires.
Enclosure assembly above is shown with cover
removed.
50
Remove empty
Screw hole
connector housing
location for
before connecting
transformer.
transformer.
Transformer
31-1000708 Rev. 4
Publicité
