Monogram ZIC363NBVRH Instructions D'installation page 23

Installation Instructions - Single Integrated Installation
STEP 2 INSTALL WATER LINE
WARNING
Connect to potable water supply
only. A cold water supply is required for automatic
icemaker operation and the water dispenser (some
models). The water pressure must be between 40
and 120 psi (275-827 kilopascals).
AVERTISSEMENT
une alimentation d'eau potable seulement. Une
alimentation d'eau froide est requise pour faire
fonctionner la machine à glaçons et le pichet à
remplissage automatique
(certains modèles). La pression d'eau doit se situer
entre 40 et 120 psi. (275 à 827 kPa).
ADVERTENCIA
suministro de agua potable únicamente. Se requiere
un suministro de agua fría para el funcionamiento de la
jarra automática de llenado y del dispensador de agua
(algunos modelos). La presión del agua deberá estar
entre 40 y 120 p.s.i. (275 – 827 kPa).
WARNING
Attach tubing clamp using existing hole only. DO
NOT drill into the refrigerator.
AVERTISSEMENT
Fixez le collier de serrage dans le trou présent seulement.
NE PERCEZ PAS dans le réfrigérateur.
ADVERTENCIA
Adhiera la abrazadera de la tubería usando el agujero
existente únicamente. NO perfore el refrigerador.
31-1000708 Rev. 4
Raccordez l'appareil à
et le distributeur d'eau
Realice la conexión a un
ELECTRIC SHOCK HAZARD
RISQUE DE DÉCHARGE
ÉLECTRIQUE
PELIGRO DE DESCARGA
ELÉCTRICA
Shut off the main water supply.
Turn on the nearest faucet long enough to clear the line
of water.
between the water valve and cold water pipe in a
basement or adjacent cabinet. The shut-off valve
should be located where it will be easily accessible.
Turn on the main water supply and flush debris. Run
about a quart of water through the tubing into a bucket.
Shut off water supply at the shut-off valve.
NOTE: Saddle type shut-off valves are not recommended
but are included in many water supply kits. Before
purchasing, make sure a saddle type valve complies with
your local plumbing codes.
NOTE: Commonwealth of Massachusetts Plumbing
Codes 248CMR shall be adhered to. Saddle
valves are illegal and use is not permitted in
Massachusetts. Consult with your licensed plumber.
Route 1/4" OD copper or SmartConnect
(WX08X10006) plastic tubing between house cold
water line and the water connection location at the
front of the unit.
™
SmartConnect Refrigerator Tubing Kits are available.
One 8' (2.4m) water line (WX08X10006) is needed for
each unit. The waterline will be taped to the floor using
masking tape after anti-tip bracket installation.
Tubing should be long enough
to extend to the front of the
unit. Allow enough tubing to
accommodate bend leading into
the water line connection.
NOTE: The only Monogram
approved plastic tubing is supplied
in the SmartConnect ™
use any other plastic water supply line because the line
is under pressure at all times. Other types of plastic may
crack or rupture with age and cause water damage to
your home.
23
a shut-off valve
™
Refrigerator Tubing kits. Do not