Monogram ZIC363NBVRH Instructions D'installation page 63

Installation Instructions - Door Panels - Single Door Models
STEP 2 PANEL INSTALL & ADJUSTMENT (Cont.)
8. Repeat steps 3-7 for the convertible drawer.
9. Repeat steps 3-7 for the freezer drawer.
10. Tighten all screws once you are satisfied with the
panel alignment.
11. Install G1 brackets on back side of refrigerator panel.
For Stainless Steel Panels: Use the M4 machine
screws provided with the stainless steel panel kit.
For Custom Panels: Use #6 phillips head wood
screws provided with refrigerator.
D1
G1
E1
12. Before installing trims, inspect bracket tabs to verify
they are not bent. Tabs must be parallel to the panel
in order to properly install the trims.
X
31-1000708 Rev. 4
A1
G1
G1
B1
13. Clip trim onto brackets to hide the panel adjustment
hardware.
14. Add trim caps to cover the ends of the trim.
NOTE: If trim caps are not flush with the top of the
door, hold the top and bottom caps when adjusting
the trim up or down so that the caps do not come
loose. Make sure the caps are flush to the trims after
adjustment.
63