Monogram ZIC363NBVRH Instructions D'installation page 57

Installation Instructions - Dual Integrated Installation
STEP 9 FINAL EXTERNAL UNIT
PREPARATION (Cont.)
Mullion Trim Installation
Open all doors and drawers.
the dart in the area between the units.
necessary.
Open both enclosure doors to 90°.
Snap the trim bracket between the water filter access
enclosures above displays.
31-1000708 Rev. 4
Mullion
Trim
"Dart"
NOTE: Doors/Drawers not
shown for clarity.
STEP 9 FINAL EXTERNAL UNIT
PREPARATION (Cont.)
If installation requires a
limiter pin(s) must be installed
- Open the door to expose the hole in the back hinge
bracket and install the limiting pin. Pin must be
fully seated in the hinge or the door will not close
properly.
STEP 10 TOE KICK INSTALLATION
Create a custom toe kick or purchase Stainless Steel
Toe Kick ZKN72V.
A toe kick magnet can be found in the box of
parts that was taped to the side of each of the
refrigerators. These will be used for custom toe kicks
only.
For custom toe kicks, adhere magnets to the back
side of the toe kick. The surface of the toe kick where
the magnets are to be placed must be clean and free
of foreign material. Center magnets vertically and
horizontally.
Position toe kick on bottom portion of front access
covers.
Dual Integrated Custom Toe Kick Dimensions
Thickness No greater than 3/4" (1.9 cm)
Width 71 7/8" (182.6 cm)
Height Determine after product is leveled
in installation space
57
90° door opening, the hinge
in the top hinge(s).