Monogram ZIC363NBVRH Instructions D'installation page 55

Installation Instructions - Dual Integrated Installation
STEP 7 INSERTING/SECURING
INTO CABINET SURROUND (Cont.)
Replace the waterline strain relief screw.
Strain Relief
Screw
Store the excess string, and water tubing under
the unit.
WARNING
Replace waterline strain relief in front rail location as
shown.
AVERTISSEMENT
d'électrocution.
Reposez la vis de décharge de
tension dans le profilé avant comme illustré.
ADVERTENCIA
Eléctrica
Reemplace el amortiguador de refuerzo de
la tubería de agua frente a la ubicación del riel, como se
muestra.
31-1000708 Rev. 4
Electrical Shock Hazard.
Risque
Riesgo de Descarga
STEP 8 LEVEL UNIT
All models have 4-point leveling. The front is supported
by leveling legs; the rear is supported by adjustable
wheels. Both are accessible from the front of the unit.
To level the back of the unit, turn the 7/16" hex nut
located above the front leveling legs. Turn clockwise
to raise or counterclockwise to lower the unit.
leveling leg or a 7/16" open-end wrench at the bottom
of the leveling leg.
opening 84". The unit should be level and plumb with
cabinetry. The front wheels must be a minimum of
1/8" (0.3 cm) off the floor.
7/16" hex nut
adjusts rear
wheels
T30 bit
adjusts front
leveling legs
NOTICE: The rear leveling wheels and front leveling
legs are limited to a maximum height adjustment of 1".
If the installation requires more than 84" height, the
installer should elevate the unit on a sheet of plywood
or runners. Cabinetry trim could also be added across
the top of the opening to shorten the opening. If you
attempt to raise the unit more than 1", you will damage
the front leveling legs and the rear leveling wheels.
55
7/16" open end
wrench adjusts
front leveling legs