Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions - Single Integrated Installation
REFRIGERATOR/FREEZER LOCATION
Do not install the refrigerator/freezer where the tem-
perature will go below 55°F (13°C). It will not run
often enough to maintain proper temperatures.
Do not install the refrigerator/freezer where
temperatures will go above 100°F (37°C). It will not
perform properly.
Do not install the refrigerator/freezer in a location
exposed to water (rain, etc.) or direct sunlight.
Install it on a floor strong enough to support it fully
loaded.
TOOLS AND MATERIALS REQUIRED
• Metal shears (recommended)
• #1, #2 Phillips screwdriver
• Flathead screwdriver
• Putty knife (recommended)
• Measuring tape
• Drill and 1/16", 5/64", 3/16", 1/2" bits
• 5/32" concrete bit (if installing anti-tip into concrete)
• 1/4", 3/8", 7/16" driver/socket
• 7/16" open wrench
• T10, T20, T30 driver/bit
• 1/8", 1/4" hex driver (allen wrench)
• Level
• Water shut-off valves (optional but recommended)
• 8' waterline
• Masking tape
• Rubbing alcohol
• 10" Adjustable wrench
• Center punch
• Stainless Steel Door Kits (if applicable)
• Custom panels for doors (if applicable)
• ZKPN (if applicable)
• Handle Kits (if applicable)
• Small Ratchet 1/4" or 3/8"
•
90° Right Angle Driver or a minimum 8" long Phillips bit
extender
HARDWARE SUPPLIED (per unit)
• Odor filter (if equipped)
• Fresh filter (if equipped)
• 2 Anti-Tip brackets
• 4 Lag screws
• 3 Tapcon screws
• (4) 1/4" Hex Screws
• Panel installation templates
• 2 Hinge limiter pins
• Door Hardware Kit
• Door Trim Kit
31-1000708 Rev. 4
GROUNDING THE UNIT
WARNING
Hazard.
Failure to follow these instructions can
result in death, fire, or electrical shock.
AVERTISSEMENT
Le non-respect de ces instructions peut occasionner un
décès, un incendie ou un choc électrique
ADVERTENCIA
Si no se siguen estas instrucciones, se podrá produ-
cir la muerte, incendios o descargas eléctricas.
The power cord of this appliance is equipped with a
3-prong (grounding) plug which mates with a standard
3-prong (grounding) wall receptacle to minimize the
possibility of electric shock hazard from this appliance.
Have the wall outlet and circuit checked by a qualified
electrician to make sure the outlet is properly grounded.
Where a standard 2-prong wall outlet is encountered, it
is your personal responsibility and obligation to have it
replaced with a properly grounded 3-prong wall outlet.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR
REMOVE THE THIRD (GROUND) PRONG
FROM THE POWER CORD.
DO NOT USE AN ADAPTER PLUG TO
CONNECT THE REFRIGERATOR TO A
2-PRONG OUTLET.
DO NOT USE AN EXTENSION CORD WITH
THIS APPLIANCE.
FLOORING
For proper installation, this product must be placed
on a level surface of hard material that is at the same
height as the rest of the flooring. This surface should
be strong enough to support a fully loaded refrigerator
or freezer, or approximately 1,200 lbs. per unit.
NOTE: Protect the finish of the flooring.
NOTE: Not recommended for installation on carpeted
flooring.
21
Electrical Shock
Risque d'électrocution
Riesgo de Descarga
Publicité
