Publicité
Les langues disponibles
Les langues disponibles
O O p p e e r r a a t t i i o o n n
P P o o w w e e r r i i n n g g t t h h e e p p r r o o d d u u c c t t o o n n a a n n d d o o f f f f
C C A A U U T T I I O O N N
• Do not block access to the hospital-grade plug or medical-grade wall outlet when placing the product.
• Electric shock risk. This equipment must only be connected to a supply mains with protective earth.
• Always plug the product directly into a properly grounded hospital-grade or medical-grade wall outlet to achieve
grounding reliability.
To power on the product, plug the power cord into a wall outlet.
To power on the product with the battery backup option, press the battery on/off switch (|/O) (A) to on (|) (Figure 2). Then,
plug the power cord into a wall outlet.
To power off the product, unplug the power cord from the wall outlet.
To power off the product with the battery backup option, press the battery on/off switch (|/O) (A) to off (O) (Figure 2). Then,
unplug the power cord from the wall outlet.
You must fully charge your battery if it has been in a deep battery discharge for an extended length of time or if you just
turned the battery on/off switch (|/O) to on (|) (Figure 2). To recharge, see Charging the battery (option) (page 19). The
battery status indicator may show battery status as critical until the charge cycle is complete.
A A p p p p l l y y i i n n g g o o r r r r e e l l e e a a s s i i n n g g t t h h e e p p a a r r k k i i n n g g b b r r a a k k e e
C C A A U U T T I I O O N N
• Always apply the parking brake when an occupant is getting into or out of the product to avoid instability.
• Always apply the parking brake when the occupant is unattended.
• Do not apply the parking brake to stop a rolling chair.
• Do not park the product on a slope or uneven surface to avoid unintended product movement.
To apply the parking brake, push down on the parking brake pedal. Push on the product to make sure that the parking
brake is working.
N N o o t t e e - - Lock illuminates white when you apply the parking brake on the operator control panel.
To release the parking brake, pull up on the parking brake pedal.
N N o o t t e e - - Unlock flashes white when you release the parking brake on the operator control panel.
S S e e a a t t i i n n g g a a n n o o c c c c u u p p a a n n t t
To seat an occupant:
1. Apply the parking brake. Push on the product to make sure that the parking brake is working.
2. Place the T T r r u u R R i i z z e e arms into the forward locking position.
3. Set T T r r u u R R i i z z e e to the Upright 1 position or Stand Assist position to seat an occupant ( Positioning the chair (page 13)).
4. Seat the occupant with their back against the backrest and arms forward.
5. Place the occupant in any comfortable position.
6. Set T T r r u u R R i i z z e e options, including lockouts and the chair exit system.
3333-009-005 Rev AA.0
11
EN
Publicité
