Noise Emission Values; Emc Measures; Disposal; Data Protection - Fronius Primo 3.0-1 Instructions De Service

Masquer les pouces Voir aussi pour Primo 3.0-1:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

It is impossible to guarantee that bought-in parts are designed and manufactured to meet
the demands made of them, or that they satisfy safety requirements. Use only original
spare parts (also applies to standard parts).
Do not carry out any modifications, alterations, etc. to the device without the manufactur-
er's consent.
Components that are not in perfect condition must be replaced immediately.
Noise emission
The inverter generates a maximum sound power level of < 65 dB(A) (ref. 1 pW) when op-
values
erating under full load in accordance with IEC 62109-1:2010.
The device is cooled as quietly as possible with the aid of an electronic temperature control
system, and depends on the amount of converted power, the ambient temperature, the lev-
el of soiling of the device, etc.
It is not possible to provide a workplace-related emission value for this device because the
actual sound pressure level is heavily influenced by the installation situation, the power
quality, the surrounding walls and the properties of the room in general.

EMC measures

In certain cases, even though a device complies with the standard limit values for emis-
sions, it may affect the application area for which it was designed (e.g. when there is sen-
sitive equipment at the same location, or if the site where the device is installed is close to
either radio or television receivers). If this is the case, then the operator is obliged to take
appropriate action to rectify the situation.

Disposal

To comply with the European Directive 2012/19/EU on Waste Electrical and Electronic
Equipment and its implementation as national law, electrical equipment that has reached
the end of its life must be collected separately and returned to an approved recycling facil-
ity. Any device that you no longer require must be returned to your distributor, or you must
locate the approved collection and recycling facilities in your area. Ignoring this European
Directive may have potentially adverse effects on the environment and your health!

Data protection

The user is responsible for the safekeeping of any changes made to the factory settings.
The manufacturer accepts no liability for any deleted personal settings.

Copyright

Copyright of these operating instructions remains with the manufacturer.
The text and illustrations are all technically correct at the time of printing. We reserve the
right to make changes. The contents of the operating instructions shall not provide the ba-
sis for any claims whatsoever on the part of the purchaser. If you have any suggestions for
improvement, or can point out any mistakes that you have found in the instructions, we will
be most grateful for your comments.
6

Publicité

Table des Matières
loading

Table des Matières