Safety Rules; General; Environmental Conditions - Fronius Primo 3.0-1 Instructions De Service

Safety rules

General

The device is manufactured using state-of-the-art technology and according to recognised
safety standards. If used incorrectly or misused, however, it can cause:
-
-
All persons involved in commissioning, maintaining and servicing the device must
-
-
-
The Operating Instructions must always be at hand wherever the device is being used. In
addition to the Operating Instructions, attention must also be paid to any generally appli-
cable and local regulations regarding accident prevention and environmental protection.
All safety and danger notices on the device:
-
-
-
-
The terminals can reach high temperatures.
Only operate the device if all of its protection devices are fully functional. If the protection
devices are not fully functional, there is a risk of
-
-
Any safety devices that are not functioning properly must be repaired by a suitably qualified
technician before the device is switched on.
Never bypass or disable protection devices.
For the location of the safety and danger notices on the device, refer to the "General" sec-
tion in the Operating Instructions for the device.
Before switching on the device, remove any faults that could compromise safety.
This is for your personal safety!
Environmental Operation or storage of the device outside the prescribed area will be deemed as "not in
conditions accordance with the intended purpose". The manufacturer shall not be held liable for any
damage arising from such usage.
Qualified service The servicing information contained in these Operating Instructions is intended only for the
engineers use of qualified service engineers. An electric shock can be fatal. Do not perform any ac-
tions other than those described in the documentation. This applies even if you are quali-
fied to do so.
All cables and leads must be secured, undamaged, insulated and adequately dimen-
sioned. Loose connections, scorched, damaged or inadequately dimensioned cables and
leads must be immediately repaired by authorised personnel.
Maintenance and repair work must only be carried out by authorised personnel.
injury or death to the operator or a third party
damage to the device and other material assets belonging to the operator.
be suitably qualified,
have knowledge of and experience in dealing with electrical installations and
read and follow these Operating Instructions carefully.
must be in a legible state,
must not be damaged,
must not be removed,
must not be covered, pasted or painted over.
injury or death to the operator or a third party
damage to the device and other material assets belonging to the operator
5