Fronius Primo 3.0-1 Instructions De Service page 15

NOTE!
If the photovoltaic system has only one inverter, steps 1 and 2 below can be skipped.
In this case, starting for the first time will commence with step 3.
Connect inverter with Fronius Datamanager 2.0 or Fronius Datamanager Box 2.0 to
1
the Fronius Solar Net
When networking several inverters together in Fronius Solar Net:
2
Set the Fronius Solar Net master / slave switch on the Fronius Datamanager 2.0 plug-
in card correctly
- One inverter with Fronius Datamanager 2.0 = master
- All other inverters with Fronius Datamanager 2.0 = slave (the LEDs on the Fronius
Datamanager 2.0 plug-in cards are not illuminated)
Switch the device to Service mode
3
- Activate the WiFi Access Point via the Setup menu on the inverter
S t a n d b y
W i F i A c c e s s P o i n t
D A T C O M
U S B
C l o c k
The inverter establishes the WiFi access point. The WiFi access point remains open for 1
hour. The IP switch on the Fronius Datamanager 2.0 can remain in switch position A due
to the activation of the WiFi Access Point.
Installation using the Solar.web App
Download the Fronius Solar.web
4
LIVE or Solar Web Pro app
Run the Fronius Solar.web app
5
The Setup wizard start page is displayed.
Installation using a web browser
Connect the end device to the WiFi
4
access point
SSID = FRONIUS_240.xxxxx (5-8
digits)
- Search for a network with the
name "FRONIUS_240.xxxxx"
- Establish a connection to this
network
- Enter the password 12345678
(Alternatively, connect the end device
and inverter using an Ethernet cable.)
Enter the following in the browser:
5
http://datamanager
or
192.168.250.181 (IP address for
WLAN connection)
or
169.254.0.180 (IP address for LAN
connection)
15