1.6. PRE-USE CHECKS
Before beginning work, carefully check that all components of the machine, especially
rubber or plastic parts, are in place, in good condition and working properly. If the inspec-
tion reveals any damage or excessive wear, no matter how slight, immediately replace
or repair the component.
1.7. DURING USE
In the event you hear any strange noise or feel unusual vibration, if a component or system
is not operating properly, or if there is anything unusual at all, stop using the machine
immediately.
• Identify the cause and take any necessary re-
medial action.
• Contact your supervisor if necessary.
Never allow any bystander to be within 20 feet of
the machine during operation.
To stop the machine in an emergency:
• disconnect the power supply plug;
• cut off the compressed air supply network by
disconnecting the shut-off valve (snap coupling).
2. TRANSPORT, STORAGE AND HANDLING
The tyre changer must be transported in its original packing and stowed in the position
shown on the packing itself.
- Packing dimensions:
• width ....................................................................................................................... 1120 mm
• depth ...................................................................................................................... 1000 mm
• height ........................................................................................................................ 970 mm
- Weight of carton packing: .............................................................................................313 kg
Machine storage and shipping specifications
Temperature: -25° - +55°C.
Do not stack other goods on top of the packing or damage may result.
Operator's manual A 222
Conditions for transporting the machine
NOTICE
2b
81