Hoisting/Handling; Installation Clearances; Important - Corghi A 222 Manuel D'utilisation

installed and connected to the pneumatic line.
T tighten the nut until P and 3-4mm.

4. HOISTING/HANDLING

In order to remove the machine from the pallet,
hook it as shown in fig.6.
This hoisting point must be used whenever you
need to change the installation position of the
machine. Do not attempt to move the machine
until it has been disconnected from the electricity
and compressed air supply systems.

4.1 INSTALLATION CLEARANCES

The machine must be installed in accordance with all applicable safety regula-
tions, including but not limited to those issued by OSHA.
RISK OF EXPLOSION OR FIRE. Never use the machine in an area where it will be
exposed to flammable vapours (gasoline, paint thinners solvents, etc.). Never install
the machine in a recessed area or below floor level.
IMPORTANT: for the correct and safe operation of the machine, the lighting level in
the place of use should be at least 300 lux.
Do not install the machine outdoors.
It is designed for use in an indoor, sheltered area.
Install the tyre changer in the chosen work position, complying with the minimum clear-
Operator's manual A 222
WARNING
DANGER
CAUTION
85