Air Pressures - Corghi A 222 Manuel D'utilisation

Model
400Volt/3ph 50Hz
200/230Volt/3ph 60Hz
200/230Volt/3ph 50Hz
200/230Volt/1ph 50Hz
200/230Volt/1ph 60Hz
A 222 TI
115Volt/1ph 60Hz
A 222
200/230Volt/1ph 50/60Hz DV
115Volt/1ph 60Hz DV
115Volt/1ph 60Hz DV cCSAus
400Volt/3ph 50Hz DV
AIR MOTOR
1.2.e. AIR PRESSURES
The machine is equipped with an internal pressure limiting valve to minimize the risk
of over inflating the tyre.
1. Never exceed these pressure limitations:
• Supply line pressure (from compressor) is 220 psi (15 bar).
• Operating pressure (gauge on regulator) is 145 psi (10 bar).
Bead setting pressure (gauge on hose) is the tyre manufacturer's maximum pressure as
stated on the sidewall of the tyre
2. Activate air inflation jets only when sealing the bead.
3. Bleed air pressure system before disconnecting supply line or other pneumatic
components. Air is stored in a reservoir for operation of inflation jets.
4. Only activate the air inflation jets if the rim securing device is locked in place and
the tyre is properly clamped (when possible).
Operator's manual A 222
Motor rating
• EXPLOSION HAZARD
• Never exceed the tyre pressure recommended by the tyre
manufacturer. Never mismatch tyre size and rim size.
• Avoid personal injury or death
Rotation Torque
kW
speed
rpm
0,75 8,5
0,75 8,5
0,75 8,5
0,75 8,5
0,75 8,5
0,75 8,5
0,75 6-15
0,75 6-15
0,75 6-15
0.9/1,25 6-12
/ 6,5
DANGER
Weight of electric/
Nm electronic part kg
1200 11,5
1200 11,5
1200 11,5
800 11,5
800 11,5
800 11,5
1200 10,2
1200 10,2
1200 10,2
900 11,6
800 /
79