Air Pressures; Risk Of Explosion; Special Rim/Tyre Considerations; Intended Use Of The Machine - Corghi ARTIGLIO UNIFORMITY Manuel D'utilisation

sary. The noise levels to which the operator is exposed to depend on numerous factors, such
as duration of exposure, characteristics of the workplace, other sources of noise etc. Permis-
sible noise exposure limits may also vary from country to country. however, this information
will enable the machine's user to make a more accurate evaluation of the hazard and risk.
1.2.e. AIR PRESSURES
The machine is equipped with an internal pressure limiting valve to minimize the risk of
over inflating the tyre.
1. Never exceed these pressure limitations:
• Supply line pressure (from compressor) is 220 psi (15 bar).
• Operating pressure (gauge on regulator) is 150 psi (10 bar).
The tyre inflation pressure (displayed on the pressure gauge) must never exceed the pres-
sure indicated by the manufacturer on the sidewall of the tyre itself.
2. Activate the air inflation jets only when inserting the bead.
3. Activate the air inflation jets only if the rim is correctly clamped on the tyre changer (if
required) and the tyre is completely mounted.

1.3. SPECIAL RIM/TYRE CONSIdERATIONS

Wheels equipped with low tyre pressure sensors or special tyre and rim designs
may require certain procedures. Consult wheels and tyre manufacturer's service
manuals.

1.4. INTENdEd USE OF THE MACHINE

This machine must be used only to remove and replace an automotive tyre on an automo-
116

• RISK OF EXPLOSION

• Never exceed the tyre pressure recommended by the tyre
manufacturer. Always match the tyre and rim dimensions.
CAUTION!
DANGER
Artiglio Uniformity User Manual