SICE S 1000 Manuel D'instructions page 151

If error messages are displayed, check the mes-
sages in the ERROR MESSAGES chapter in this
manual.
44
2. Select UPDATE P3K then press the confirm but-
ton (Fig. 44a).
The message shown in Fig. 44b is displayed.
- If the update does not start after 10 attempts,
an error message is displayed (Fig. 44c).
Press the confirm key
previous screen, then repeat the steps from
point 1.
- If the update starts, a progress message on new
file loading will be displayed (Fig. 44d).
- If file loading is interrupted, the message in
Fig. 44e will be displayed.
3. After loading, the message in Fig. 44f will be
displayed.
User manual S 1000
UPDATE P3K
1. Insert the USB key with the updated software into the USB
port (Fig. 44) of the S 1000 and wait 10 seconds.
to go back to the
44d
43a
44a
44b
UK
44c
44e
151