SICE S 1000 Manuel D'instructions page 158

Intended operating conditions
The camera has been designed exclusively to display operations carried out on the tyre
underside, as described in this manual. Any other use is inappropriate.
Technical data
-power supply..................24Vcc
OPERATION
- Press the key to use the camera.
- An image of the tyre underside will appear on the
display (Fig. 47a).
Luminosity will be automatically configured.
If the image is not optimal, press the and
keys, pressing gently on the right side of
47a
the display, to manually adjust luminosity. The
configuration will be automatically stored and kept
each time the camera is used again.
- Press the key in the top left-hand corner
to go back to automatic mode.
- Press the middle of the display to exit the applica-
tion and return to the main screen (see Fig. 47b).
47b
Note: If the camera is not used for more than 5
minutes, the main screen will appear automatically.
TROUBLESHOOTING
The camera does not show any images
Cable disconnected from camera
- Connect the cable (Fig. 47c)
Camera failure
- If the problem persists, contact the technical
assistance.
The image is out of focus
The optics are not set properly
- Contact the technical assistance
47c
User manual S 1000
158