Cleaning And Maintenance; Troubleshooting - MediaShop Vibroshaper E380 Instructions De Mise En Service Et D'utilisation

Automatic mode: Here, the device follows a predefined exercise programme, but still allows the tempo and length to be set
manually. When using automatic mode, follow these instructions:
1. Plug the Vibroshaper into a power socket and press the power switch (3) so that it is in the ON position.
2. Press the "ON" button on the control panel (15) or the
3. There are three different exercise programmes (P1, P2 and P3) available. Press button (16) on the control panel repeatedly or the
button on the remote control repeatedly until the programme you want appears on the programme display (8).
4. The next chart shows the exercise tempo of each programme depending on the length:
TIME
(minutes)
9
8
7
6
5
4
3
2
1
5. Once you've selected your chosen programme, start the exercise by pressing (17) on the control panel or
remote control.
6. To stop the device at any time, press the button (18) on the control panel or the
completed the exercise, turn the device off by pressing (15) on the control panel or the button

CLEANING AND MAINTENANCE

• Before cleaning your Vibroshaper, you must make sure that the power switch is in the OFF position and that the cable has been
unplugged from the power socket.
• You can use a clean, dry broom or brush to remove dust from the device.
• The standing area can be cleaned with a damp cloth.
• Do not use corrosive agents to clean the device, because these could damage it.
• Clean the remote control with clean cloth.
• If the device is not being used for an extended period of time, put it back in its box and store it in a cool, dry place. You should
also take the batteries out of the remote control.
• If the device appears to have a defect, follow the instructions in the Troubleshooting section. If the problem persists,
please contact our customer service team.

TROUBLESHOOTING

The device is not running.
The remote control
is not working.
The device suddenly
stopped running.
The device isn't moving.
The remote control can't
be used to stop the device
while the device is running.
P1
16
18
28
38
48
58
48
38
28
BEGINNERS
PROBLEM
The cable is not plugged
into a socket.
The power switch is in the OFF position.
The batteries are weak.
The remote control is too far
away from the device's infrared sensor.
The end of the programmed exercise
period has been reached.
The device has been given too many com-
mands and is not able to fulfil them all.
The batteries are weak.
The On/Off
button on the remote control.
TEMPO FOR EVERY PROGRAMME
P1
20
40
60
80
99
40
99
40
99
MODERATELY ADVANCED
CAUSE
Plug the cable into a socket.
Put the power switch in the ON position.
Change the batteries.
The infrared signal's range is two metres.
Reset the exercise period.
Turn off the device, wait one
minute and turn it on again.
Change the batteries.
button has been pressed. Press the Start/Stop
P3
10
44
99
33
99
22
99
11
99
ADVANCED
button on the remote control. Once you've
on the remote control.
SOLUTION
button.
on the
17