Using Your Vibroshaper For The First Time; Vibroshaper Parts And Buttons - MediaShop Vibroshaper E380 Instructions De Mise En Service Et D'utilisation

• Do not poke fingers or foreign bodies into the space between the middle and bottom panels of the device.
• Do not use the device after consuming alcohol.
• Wait at least one hour after eating before using the device.
• Before using your Vibroshaper, place it on a flat, stable and even floor or mat and ensure it is
positioned at least 100 cm from the wall and any other objects nearby.
• Before using the device, remove jewellery, your mobile phone and any other valuables, keys and sharp objects
from your person to avoid damage or injuries.
• To avoid injuries, do not jump or kneel down on the device while it is running.
• Only one person at a time may ever stand on the device.
• To prevent the device from tipping over, do not rest more weight on one side than on the other.
• Do not place any other devices or objects on your Vibroshaper in addition to your own weight.
• If there are fluctuations in your electricity supply, do not use the device and unplug it immediately.
• Keep the device away from damp areas and direct sunlight, and do not leave it outside.
• Always keep the device away from liquids. Do not touch it with wet hands, move it suddenly or jerkily, and never smoke
when using it.
• If there are problems with the power switch, do not touch the device; if you do, you could get an electric shock.
• Do not use the device if the room temperature exceeds 40 °C.
• Only connect your Vibroshaper to an electricity supply that is compatible with the device' s technical data and complies
with the instructions.
• Be careful when pressing the power switch.
• Do not kink the cable or touch it with wet hands.
• Stop using the device and unplug it immediately if a thunderstorm starts outside.
• To avoid any electrical interference, do not plug any other devices with a high power demand into the same socket as
your Vibroshaper.
• Only transport the device as per the diagram and the instructions regarding this.
• Never store inflammable substances near the device.
• Do not use new and old batteries or batteries of different brands together in the remote control.
• This equipment complies with EN ISO 20957-1 class H (H = domestic use)

USING YOUR VIBROSHAPER FOR THE FIRST TIME

• To transport your Vibroshaper, grip the handle on the right-hand side of the device and tilt the
device until its wheels touch the floor. Then pull the handle to move the device carefully.
• Ensure that the Vibroshaper is standing on a flat, stable and even floor or mat andthat the device
is positioned at least 100 cm from walls and other objects when you stop.
• When using your Vibroshaper for the first time, you should sit on a chair and place your feet on
the device. Now turn on the device to test the intensity of the movements. This allows you to get
used to the oscillations and your chosen operating mode.
• Always wear comfortable clothing and footwear when training.

VIBROSHAPER PARTS AND BUTTONS

1. Non-slip top panel
2. Non-slip rubber supports
3. Power switch
4. Power connection point
5. Bottom panel
6. Middle panel
7. Wheels to transport the device
8. Time and programme display
9. Tempo and programme display
10. Infrared receiver for the remote control
11. Extends the time
12. Shortens the time
13. Increases the tempo
14. Decreases the tempo
15. ON/OFF
16. Used to select a programme
17. Starts an exercise
18. Stops an exercise
19. Elastic bands with Fit TENSOR technology
Rear view
1
6
5
19
11
12
100 cm
Handle
Transport wheels
2
3 4
Detailed view of the control panel
8 10 9
15 16 17 18
100 cm
100 cm
100 cm
7
13
14
15