Rohm CAPTIS-M Traduction Du Manuel D'utilisation Original page 64

3 | Product Description
Cross-section
11
10
9
8
7
6
5
4
1 Basic body
2 Fixing screw
3 Piston
4 Connecting screw
5 Holding screw
6 Spiral ring
The collet chuck is a chuck suitable for rotating use in lathes or for station-
ary use in drilling, milling and machining centres, measuring machines as
well as for conventional and manual handling.
The collet chuck is operated manually and works without a clamping cylin-
der. Various collets and clamping mandrels can be replaced within a short
time with the changing device. The collets (4) and clamping mandrels are
pushed into the holder (3) and locked. The repeatability is less than 0.01
mm. The collet chuck is mounted on the machine or on a flange / base plate
with the mounting screws (2).
On request, a large number of various flanges is available. As an option, a
stop (8) and a mandrel can be mounted.
64 / 240
1
7 Protective sleeve
8 Workpiece stop
9 Clamping nut
10 Drive
11 Flange
1242467 CAPTIS-M
2
3