Emergency Stop Button And Horn; Machine Usage Advice; Notausschalter Und Hupe; Gebrauchshinweis - Numatic TTV678-300 Mode D'emploi

Emergency-stop button and horn
Fig.34
!

Machine in use

Fig.36
Fig.37
26
The TTV-678 is equipped with an electronic braking system.
Simply lift your foot from the accelerator and the machine will stop.
In an emergency, strike the emergency-stop isolator button
The machine will be disabled.
To reset, turn isolator button clockwise (see fig.34).
After re-setting the emergency stop button, to restart the
machine ,turn the ignition key to the off then the on
position again.
The horn is located on the right-hand side of the operator
control panel (see fig.35)
ALWAYS ENSURE THAT THE FLOOR IS PRE-SWEPT
AND RELEVANT SAFETY SIGNS ARE DISPLAYED.
To operate, select forward or reverse, press the accelerator-
pedal. Vacuum pick-up, water-flow and chemical-dose will
turn on automatically and the machine will move forward.
The clean water / chemical mix is dispersed evenly via
'THRU- FEED' scrubbing brushes.
The waste water is then retrieved by the suction floor-tool
(see fig.36). Overlap each scrubbing path by 10cm to ensure
an even clean.
Do not operate the machine on inclines that exceed 11%.
235670 02/12 (A09)
NOTE: Care must be taken to reduce speed when
cornering or when manoeuvring around obstacles
If streaking occurs wipe floor-tool blades clean (see fig.37).
On heavily soiled floors use a 'double scrub' technique.
First pre-scrub the floor with the floor-tool in the raised
position, allow the chemical time to work then scrub the
area a second time with the floor-tool lowered.
Fig.35
!