Regular Maintenance; Tanks And Filters - Numatic HT4045 Notice Originale

!
The TT Range has been designed with ease of use in mind, this included easy stripping-
down and cleaning. After use, empty waste-water tank using emptying hose and flush
out with clean water (Fig.24).
26
25
27
Remove the filter fitted into the separator and flush with clean water (Fig.27) (Fig.28).
Placed into the top tank is grey filter basket, clean and flush with clean water (Fig.29) (Fig.30).
31
ALWAYS ENSURE THAT THE BATTERY IS DISCONNECTED
PRIOR TO ANY MAINTENANCE OPERATION
28
The Bottom (Clean Water) tank is attached to the chassis and should only be removed by a
competent service engineer (Fig.31).
Clean by flushing with clean water if required.
Excess water can be drained using the clear dump hose fitted to the rear of the machine.
Located under the left hand side is a clean water filter, ensure the clean water tap is turned
off before removing this filter (Fig.32).
Clean and flush with clean water if required.
32
Remove the two hoses to disconnect the separator from the machine
(Fig.25).
Lift off the separator. The separator has a sealing-rubber which should be
examined at every clean-down (Fig.26).
Rinse using clean water.
29

Regular Maintenance

24
30
T 01460 68600
!
17